block-replace-start

Description                                                    Use this command to enter block-replace configuration mode.

Syntax                                                                  block-replace-start

This command takes you to the Block-replace configuration level, where all configuration commands are available.

Default                                                                Disabled.

Mode                                                                   Global configuration mode.

Usage                                                                  This command enters block-replace configuration mode but leaves the ACOS device up. While in block-replace mode, new configurations will not be entered into the running con­figuration. At the block-replace configuration level, you can enter a new configuration which you want to replace the running configuration. All of the running configuration will be replaced when ending block-merge mode. If an object that exists in the running configura­tion is not configured in block-replace, then all configurations for that object will be removed upon ending block-replace mode.

Table of Contents

Index

Glossary

-Search-

Back