health-test

Description                                                    Test the status of a device at a specified IP address using a defined health monitor.

To configure a health monitor, use the health monitor command.

Syntax                                                                  health-test ipaddr [count num] [monitorname name] [port portnum]

Parameter

Description

ipaddr

IPv4 or IPv6 address of the device you want to test.

count num

Wait for count tests (1-65535).

The default count is 1.

monitorname name

Specify the pre-configured health monitor to use for the test.

port portnum

Specify the port to test.

Mode                                                                   Configuration mode

Table of Contents

Index

Glossary

-Search-

Back