mac-address

Description                                                    Configure a static MAC address.

Syntax                                                                  [no] mac-address mac-address port port-num vlan vlan-id
[trap {source | dest | both}]

Parameter

Description

mac-address

Hardware address, in the following format:
aabb.ccdd.eeff

port port-num

ACOS Ethernet port to which to assign the MAC address.

If the ACOS device is a member of an aVCS virtual chassis, specify the interface as follows:
DeviceID/Portnum

vlan vlan-id

Layer 2 broadcast domain in which to place the device.

trap

Send packets to the CPU for processing, instead of switching them in hardware.:

  source – Send packets that have this MAC as a source address to the CPU.

  dest – Send packets that have this MAC as a destination address to the CPU.

  both – Send packets that have this MAC as either a source or destination address to the CPU.

NOTE:                                                                   The trap option is supported on only some AX models: AX 3200-12, AX 3400, AX 5200-11 and AX 5630.

Default                                                                No static MAC addresses are configured by default.

Mode                                                                   Configuration mode

Example                                                            The following command configures static MAC address abab.cdcd.efef on port 5 in VLAN 3:

ACOS(config)#mac-address abab.cdcd.efef port 5 vlan 3

Table of Contents

Index

Glossary

-Search-

Back