reload

Description                                                    Restart ACOS system processes and reload the startup-config, without rebooting.

Syntax                                                                  reload [all | device device-id]

Parameter

Description

all

When VCS is enabled, this parameter causes all devices in the virtual chassis to be reloaded.

When VCS is disabled, this parameter causes only the device on which this command is run to be reloaded.

device-id

When VCS is enabled, this parameter causes only the specified device to be reloaded.

When VCS is disabled, this parameter will return an error message.

Mode                                                                   Privileged EXEC mode

Usage                                                                  The reload command restarts ACOS system processes and reloads the startup-config, with­out reloading the system image. To also reload the system image, use the reboot command instead. (See reboot.)

The ACOS device closes all sessions as part of the reload.

If the reload command is used without any optional parameters (see example below) then only the device on which the command is run will be reloaded. This is the case for both VCS-enabled and VCS-disabled devices.

Example                                                            Below is an example of the reload command:

ACOS(config)#reload

Reload ACOS ....Done.

ACOS(config)#

Table of Contents

Index

Glossary

-Search-

Back