show interfaces

Description                                                    Display interface configuration and status information.

Syntax                                                                  show interfaces
[brief] |
[ethernet [num]] |
[ve [num]] |
[lif num] |
[loopback num] |
[management] |
[
trunk [num] |
[tunnel num]] |
[media] |
[statistics] |
[transceiver]

Mode                                                                   Privileged EXEC level and configuration levels

Usage                                                                  If no specific interface type and number are specified, statistics for all configured interfaces are displayed. See the examples below.

     For information about the brief option, see show interfaces brief.

     For information about the media option, see show interfaces media.

     For information about the statistics options, see show interfaces statistics.

     For information about the transceiver option, see show interfaces transceiver.

Example                                                            The following example shows information for Ethernet port 1:

ACOS#show interfaces ethernet 1

Ethernet 1 is up, line protocol is up

 Hardware is GigabitEthernet, Address is 0090.0b0a.a596

 Internet address is 10.10.10.241, Subnet mask is 255.255.255.0

 Internet address is 10.10.10.242, Subnet mask is 255.255.255.0

 Internet address is 10.10.10.243, Subnet mask is 255.255.255.0

 Internet address is 10.10.10.244, Subnet mask is 255.255.255.0

 Internet address is 10.10.11.244, Subnet mask is 255.255.255.0

  Configured Speed auto, Actual 1Gbit, Configured Duplex auto, Actual fdx

  Member of L2 Vlan 1, Port is Untagged

  Flow Control is enabled, IP MTU is 1500 bytes

  Port as Mirror disabled, Monitoring this Port disabled

 0 packets input,  0 bytes

 Received 0 broadcasts,  Received 0 multicasts,  Received 0 unicasts

 0 input errors,  0 CRC  0 frame

 0 runts  0 giants

 0 packets output  0 bytes

 Transmitted 0 broadcasts  0 multicasts  0 unicasts

  0 output errors  0 collisions

  300 second input rate: 158073232 bits/sec, 154368 packets/sec, 15% utilization

 300 second output rate: 35704 bits/sec, 5 packets/sec, 0% utilization

 

Example                                                            The following example shows information for loopback interface 8:

ACOS#show interfaces loopback 8

Loopback 8 is up, line protocol is up

 Hardware is Loopback

 Internet address is 10.10.10.55, Subnet mask is 255.255.255.0

 

Example                                                            The following example shows Virtual Ethernet (VE) interface statistics:

ACOS#show interface ve 10

VirtualEthernet 10 is up, line protocol is up

 Hardware is VirtualEthernet, Address is 001f.a004.c0e2

 Internet address is 110.10.10.1, Subnet mask is 255.255.255.0

 IPv6 address is 2001:10::241 Prefix 64 Type: unicast

 IPv6 link-local address is fe80::21f:a0ff:fe04:c0e2 Prefix 64 Type: unicast

 Router Interface for L2 Vlan 10

 IP MTU is 1500 bytes

 28 packets input  2024 bytes

 Received  0 broadcasts, Received 24 multicasts, Received 4 unicasts

 10 packets output  692 bytes

 Transmitted  8 broadcasts, Transmitted 2 multicasts, Transmitted 0 unicasts

 300 second input rate: 48 bits/sec, 0 packets/sec

 300 second output rate: 16 bits/sec, 0 packets/sec

Table of Contents

Index

Glossary

-Search-

Back