show ip fib | show ipv6 fib

Description                                                    Display Forwarding Information Base (FIB) entries.

NOTE:                                                                   This command is applicable only on ACOS devices that are configured in route mode. The command returns an error if you enter it on a device configured for transparent mode.

Syntax                                                                  show {ip | ipv6} fib

Mode                                                                   All

Example                                                            The following command shows the IPv4 FIB entries on an ACOS device configured in route mode:

ACOS#show ip fib

Prefix                 Next Hop        Interface       Distance

------------------------------------------------------------------------

0.0.0.0 /0             192.168.20.1    ve10            0

192.168.20.0 /24       0.0.0.0         ve10            0

Total routes = 2

Example                                                            The following command shows IPv6 FIB entries:

ACOS(config)#show ipv6 fib 

Prefix                      Next Hop        Interface       Metric     Index

----------------------------------------------------------------------------

b101::/64                   ::              Ethernet 6      256        0   

Total routes = 1

Table of Contents

Index

Glossary

-Search-

Back