show ip interfaces | show ipv6 interfaces

Description                                                    Display IP interfaces.

Syntax                                                                  show {ip | ipv6} interfaces 
[ethernet num] |
[
ve num] |
[
loopback num] |
[
management] |
[
trunk [num]] |
[
lif [num]]

Mode                                                                   All

Example                                                            The following command shows the IPv4 interfaces configured on Ethernet interface 1:

ACOS#show ip interfaces ethernet 1

IP addresses on ethernet 1:

 ip 10.10.10.241 netmask 255.255.255.0 (Primary)

  ip 10.10.10.242 netmask 255.255.255.0

  ip 10.10.10.243 netmask 255.255.255.0

  ip 10.10.10.244 netmask 255.255.255.0

  ip 10.10.11.244 netmask 255.255.255.0

Example                                                            The following command shows the IPv4 interfaces configured on VEs:

ACOS#show ip interfaces ve

Port IP              Netmask         PrimaryIP

--------------------------------------------------

--------------------------------------------------

ve4  60.60.60.241    255.255.255.0   Yes     

     50.60.60.241    255.255.252.0   No      

--------------------------------------------------

ve6  99.99.99.241    255.255.255.0   Yes

The PrimaryIP column indicates whether the address is the primary IP address for the interface. (For more information, see the ip address command in the “Config Commands: Interface” chapter of the Network Configuration Guide.

Table of Contents

Index

Glossary

-Search-

Back